Die Stacking is the process of mounting multiple chips on top of each other within a single semiconductor package. Die stacking, which is also known as ‘chip stacking’, significantly increases the amount of silicon chip area that can be housed within a single package of a given footprint, conserving precious real estate on the printed circuit board and simplifying the board assembly process. Aside from space savings, die stacking also results in better electrical performance of the device, since the shorter routing of interconnections between circuits results in faster signal propagation and reduction in noise and cross-talk.
Early applications of best stacked dies involved the stacking of two memory chips on top of each other, such as Flash and SRAM devices. Today, however, die stacking technology has advanced beyond ‘mere’ memory chip stacking, and may now involve six or more chips of varying function or technology, e.g., logic, analog, mixed-signal, etc. Indeed, die stacking is now synonymous with ‘vertical integration’, or the integration of circuits in vertical fashion instead of the traditional horizontal or planar approach.
Die stacking naturally started out with a pyramid style of piling up smaller die on top of larger ones. The technology has advanced into something that finds no limit in the sizes of chips to stack. It is now common to see a stack of equal-size die, or even a larger die on top of a smaller one. One technique developed is to place a spacer (a dummy layer of silicon) between two die, so that the bond wires are not crushed even if the top die is larger than the bottom die. Unfortunately, the use of spacers between die add to the total package thickness.
Tessera Inc. pioneered the technique of folding stacked die to eliminate the need for spacers between them, calling the process ‘folded/stacked’ technology. The die are produced side by side and then folded over so that the bond pads are independent of each other. A relieving layer is placed between the chips to alleviate thermomechanical stresses.
Stacked die may be interconnected using wirebonding alone, or by a combination of wirebonding and flipchip assembly. The use of wirebonding as the exclusive means of interconnection is somewhat restrictive, since the number of stacked die that may be wirebonded may be limited to only three. Nonetheless, a common technique employed for wirebonding stacked die is to wirebond each die individually to the substrate. The conductor patterns on the substrate take care of interconnecting the die to each other and to the outside world.
Die that are wirebonded to the substrate must have a 0.5-1 mm shelf or exposed area around its periphery to allow the formation of the necessary loops during wirebonding. Die-to-die wirebonding is also done, but this requires the bottom die to be sufficiently larger than the top die, to allow enough room for the wirebond connections. Wirebonding of stacked die could call for loop heights that are less than 100 microns, which are much more challenging than loop heights of 150-175 microns commonly seen in conventional wirebonding of unstacked die.
Wafer thinning, thin-wafer handling, and thin die attach are essential elements of successful die stacking. Wafer thinning still involves conventional wafer backgrinding, but it must be followed by a polishing step that relieves stresses imparted by the backgrind process to the wafer. Wafers intended for die stacking can be thinned to just 3-6 mils, depending on the use and the wafer size. Wafers that are this thin are already inherently weak, and require special handling and transport systems to ensure their proper support at all times. Die attach of very thin die, in particular, can be very challenging. The application of preformed tape epoxy on the wafer backside prior to sawing is one technique that facilitates die attach of very thin die. Find more details
